6
Boiling water
• Take hold of the base station and unwind the
cable as far as it goes.
• Open the lid and ll the unit with water
Important
Make sure you do not exceed the internal maxi-
mum lling level mark.
Fill the unit so that the water level is denitely
between the minimum and maximum indicator
line.
• Close the lid and put the unit back onto the
base station.
• Plug the plug into the electric socket.
• Push the on/off switch.
• The unit is now switched on.
• As soon as boiling stops, the unit automati-
cally shuts off.
• The indicator light extinguishes.
• If desired, you can press the on/off switch
again to boil the water once more. However,
before doing that, please wait about 30 sec.
after the unit automatically shut itself off.
Lime lter
The removable lime lter prevents lime scale
being poured out.
Dry running and overheating protection
This unit is equipped with a dry running and
overheating protection system. If you ever op-
erate the unit without any water or with too
little water, the unit shuts itself off. Wait a mo-
ment until the unit has cooled off. Fill the unit
with water and continue as usual.
Lift-off shut-off
If you happen to lift the unit off the base sta-
tion while boiling, the unit shuts itself off. This
is the so-called lift-off shut-off.
Cleaning
First pull the plug out of the electric socket
and let the unit cool off.
Clean the exterior of the unit with a soft,
moist cloth. If heavily soiled, you can use a
mild detergent.
To Next Page
Loading...
