4. Operation of the Control System
8 / 19
4.2.2 Manual Control of the Valve using “Manual Operation”
During checks, each valve should run for at least 5 seconds, as the monitoring the current consumption of
the valves takes some time before any faults are detected.
In automatic mode, first press then the arrow key until the following is displayed on the screen:
By pressing on the button again, you will receive the following message:
Pressing allows you to turn the selected programme on and off.
The other programs can be selected using the arrow keys .
Pressing once will take you back to the display “manual mode”.
4.2.3 Set Date/Time
Press and then the arrow keys until the following is displayed on the screen (example):
By pressing , the time and date can then be set using the arrow keys .
To confirm the correction, you must press each time.
Pressing once will take you to the next display in holiday mode.
A correctly set system clock and date display is absolutely mandatory in order to record the hours of opera-
tion and so that any faults can be traced. There is no automatic change from summer to winter time.
NOTE: If you do not press any buttons for a period of 10 minutes, normal operation will begin automatically.
To Next Page
Loading...
