14
NOTES:
1. Factory set at 0 Vdc.
2. Factory set for 90 Vdc for 120V controllers, 180 V dc for 240 V controllers.
3. Factory set for 100% of controller rating.
4. Factory set for zero compensation.
5. Factory set for 1/2 second.
6. Factory set for 1/2 second.
7. If half wave field is required, motor field windings are to be connected
between F1 and L1.
8. Factory set to accept 0 - 5 Vdc; cut J2 for 0 - 10 Vdc operation.
*Verify that INHIBIT Is properly
wired for application. See
pages 14 & 15 for details.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...