16
UNIT FUNCTIONS CONTINUED
To program the S1000 for either a NO or NC type INHIBIT
conditions, the unit’s logic should be set with Jumper J1. Jumper
J1 is a 10K ohm; 1/4 watt resistor which is located between the
inhibit and SP2 terminals on the S1000 circuit board. See
Component Location page 21 for further information. The two
methods for using the INHIBIT are described further on the
following page.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...