20
2. Set the Speed Pot to Minimum Speed (CCW), and place the
external RUN/STOP switch in the STOP position
3. Apply power to the control. Place the RUN/STOP switch in
the RUN position. The RUN (green) LED should glow, but the
motor should not turn. If LED does not come on, verify that
INHIBIT is not activated.
4. Slowly rotate Speed Pot in a clockwise direction. Motor
should begin turning. Continue to rotate Speed Pot until
desired motor speed is achieved.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...