6
Location
When receiving the counter, check the packaging material for damage.
If any damage occurs at the packaging material, it should be considered if the cabinet might have
been damaged too. If the damage is substantial, please contact your dealer.
The transport pallet can be removed by loosening the screws that fasten the pallet to the counter.
This task requires at least 2 persons.
Fig. 1
If the counter has been transported in horizontal position it must stand upright at
least 2 hours before it is started to allow the oil from the compressor to run back.
Because of the heavy weight of the counter, the floor might be damaged or
scratched when moving the cabinet.
Correct set up gives the most effective operation.
The counter should be located in a dry and adequately ventilated room.
To ensure efficient operation, it may not be placed in direct sunlight or against heat-
emitting surfaces. The counter is designed to operate in an ambient temperature
between +16C and +40°C.
Avoid placement of the counter in a chlorine/acid-containing environment (swimming
bath etc.) due to risk of corrosion.
The counter and parts of the interior is equipped with a protecting film, which should
be removed before use.
Clean the counter with a mild soap solution before use.
To Next Page
Loading...
Need help?
General
