What to do if my Gram Hob does not respond and emits an extended beep?
If your Gram Hob isn't responding and beeping, it could be due to improper use, like touching the wrong sensor fields or not touching them long enough. Try reconnecting the hob. Alternatively, the sensor fields might be covered or dirty, so uncover or clean them.
Why Gram KKI 7154-91 TI sensor fields do not respond when touched?
If your Gram Hob sensor fields aren't responding to your touch, there could be a few reasons: * The appliance might not be turned on, so ensure it's switched on. * You might be touching the sensor field too briefly; try touching it for longer than one second. * You might be touching multiple sensors at once; make sure to touch only one sensor field at a time (except when switching off a cooking zone).
Why does my Gram KKI 7154-91 TI Hob switch itself off?
If your Gram Hob switches off by itself, it could be due to a couple of reasons: * If no sensor field is touched for 10 seconds after activating the appliance, it will switch off. To prevent this, switch on the appliance and set the heat setting without delay. * The sensor fields might be covered or dirty, so uncover or clean them.
What to do if a single cooking zone switches off and residual heat indicator „H” is shown on Gram KKI 7154-91 TI Hob?
If your Gram Hob cooking zone switches off and shows the residual heat indicator „H”, it could be due to the limited cook time feature. Simply switch the cooking zone on again. It can also happen if the sensor fields are covered or dirty, so ensure they are clean. Overheating of electronic components may also cause this issue.
Why is the residual heat indicator extinguished on my Gram Hob even though the cooking zones are hot?
If the residual heat indicator on your Gram Hob is off even though the cooking zones are hot, it's likely due to a power outage or the appliance being disconnected. The indicator will reappear the next time you turn the appliance on and off.
To Next Page
General