Grammer MSG 90.6PG - Page 204

Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
3.21 Cable for electro-pneumatic gearshift (EPS) – removal and installation
Page 5 of 6
REMOVAL / INSTALLATION TABLE OF CONTENTS
11 For seat model Actros:
11.1 Remove the plug of the EPS cable
at the pin contact strip (see
Chapter 3.39).
11.2 Mark the point where the EPS
cable (1) is fastened to the
swinging structure (10) by means
of cable tie (5) and remove the
cable tie (5).
Installation note:
For easier fastening of the cable
tie (5), remove the operator
console at the fore/aft adjustment
(see Chapter 3.39).
1
9
8
7
1
6
6
4
2
3
1
5
10
2190
3
2
4
5