Grammer MSG 90.6PG - Page 298

Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
3.34 Lateral support adjustment – removal and installation
Page 4 of 7
REMOVAL / INSTALLATION TABLE OF CONTENTS
8 Mark the point where the air hose for
the right chamber (7) is fastened to
the backrest frame (2) by means of
cable ties (9) and remove the cable
ties (9).
9 Lateral support adjustment,
left (1):
9.1 Carefully pull off the foam plastic
part (3) in the area of the left lateral
support adjustment (1) at the
backrest frame (2).
Installation note:
Glue together the foam plastic part
(3) and the backrest frame (2) at the
provided bonding surfaces by means
of appropriate adhesive (e.g. Dunlop
upholstery glue).
9.2 Drill off two rivet heads, drive out the
blind rivets (10) and remove the
washer (11).
2
3
1
5
12 2 9
7
3
6
8
2
4
3
2
1
1
5
10
10
11
11
12
4
3
2237