Granby KLR-100 User Manual

!
!
!
!
!
!
!
!
OIL FIRED LOBOY FURNACE -
85% + EFF I C I EN C Y
!
K LR-100
K LR-200
K LF-100
KLF -200
!
!
!
!
!
!
!
KLR-100 & 200 KLF-100 KLF-200
!
!
!
!
!
!
!
!
!
!
!
Please read the manual in its entirety before beginning installation. This
manual must be kept with the boiler for future reference. For maintenance
or question, please refer to your installer – contractor directly.
!
18-06-2017 G2017-E1 Rev.I
Installation, Operation and
Service
Manual
INSTALLATIONS MUST MEET ALL LOCAL AND CODES THAT MAY
DIFFER FROM THIS

Granby KLR-100 Specifications

General

Brand	Granby
Model	KLR-100
Category	Furnace
Language	English

Summary

1.0 Important Safety Advice

3.0 Furnace Installation

3.1 Placement and Venting

Instructions for furnace placement, floor support, and chimney/vent system installation, including condensation management.

3.2 Electrical Requirements

5.0 Burner Installation and Specifications

5.1 Setting the Burner for Efficient Operation

Guides on setting burner parameters like firing rate, pump pressure, air settings, draft regulator, and sampling hole.

5.2 Combustion Test Procedures

Outlines the steps for performing combustion tests, including smoke and CO2 readings, and adjustments.

6.0 Furnace Operation and Settings

6.1 Fan Timer Control Board (ST9103A1028)

6.4 Servicing the Fan Timer ST9103A1028

Provides a step-by-step troubleshooting guide for the Honeywell ST9103A1028 fan timer control board for no-heat conditions.

7.0 Service and Maintenance

7.1 Blower Removal and Maintenance

8.0 Electrical Wiring Diagrams

8.1 Heating & Cooling Riello/Beckett Wiring Diagrams

Wiring diagrams for KLR/KLF Riello and Beckett burner models in heating and cooling modes.

8.2 Heating Only Wiring Diagram

Wiring diagram specific to heating-only configurations for Riello and Beckett burners.

10.0 Start-Up Test Results

10.1 Test Procedures and Readings