93
Plumbing Systems
4. Turn ON the water at the water source.
5. Enter the RV and open the cold water supply faucets
to bleed air from the water lines. When the water lines
are nearly full, you may experience some air pockets.
Allow them to escape before closing the cold water
supply faucets.
6. The supply lines and faucets will fill, followed by the
water heater.
To disconnect the city water fill
1. Shut OFF the water at the water source.
2. Disconnect the non-toxic drinking water hose.
Filling the fresh water tank (gravity fill only)
Follow these directions to fill the fresh water tank if you are
not at a campground or other facility where the RV can be
hooked up to an external, pressurized water source.
1. If needed, sanitize the RV water system
(see Sanitization).
2. Insert a non-toxic drinking water hose in the gravity
water fill inlet.
3. Turn ON the water at the water source.
4. Shut OFF the water source when the fresh water tank is
full or water comes out of the fresh water tank overflow
tubes (whichever comes first).
5. Keep the fresh water tank drain closed while camping,
stored with the RV NOT connected to a water source,
or stored with NO water in the tank.
6. Open the fresh water tank drain valve to drain the fresh
water tank.
Dry camping
• Fill the Fresh Water Tank BEFORE camping.
• Turn ON the Water Pump Switch to use the water system.
Fresh Water
Gravity Fill Inlet
City Water Inlet
To Next Page
Loading...