92
Plumbing Systems
Fresh Water Connections
There are two types of direct exterior fresh water connections
in your RV: The city water fill is typically used at a campground
when there is access to an external, pressurized potable water
source. The gravity water fill is generally used to fill the fresh
water tank when dry-camping.
To use the city water fill:
1. If needed, sanitize the RV water system
(See page 99 Sanitizing the Fresh Water System)
2. Attach a non-toxic drinking water hose to the
city water inlet.
3. Adjust the City Water Control Handle (blue lever):
• Select CITY WATER or FRESH TANK FILL
BEFORE turning on the water supply.
• To prevent harm to the valve, when water
pressure is turned on, DO NOT adjust the
City Water Control Handle.
a. To fill the fresh water tank for use while dry
camping, turn the city water control handle
as shown below:
b. For normal city water use at a campground,
turn the city water control handle as shown below:
DO NOT remove
the following label
from your RV.
The fresh water connection
should be unplugged
(i.e. the non-toxic drinking
water hose disconnected)
when the RV is left unattended
for any amount of time.
If something would happen
to the water system, this
may help limit water damage
to a smaller area.
To Next Page
Loading...