EasyManua.ls Logo

Grand Design Imagine - Running Lights

Grand Design Imagine
180 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
146
Basic Troubleshooting
Should your air conditioner still not work after the
above checks have been made, contact a qualified
service facility to perform more extensive testing.
RUNNING LIGHTS
Running lights not working
Blown fuse. Replace fuse with one of the same am-
pere rating.
Bad bulbs. Replace the bulbs with new.
SLIDE-OUT
Room move in and out very slowly, binds or squeaks
Lubricate the slide-out tubes and rollers with light
spray lube.
Water is getting in at the bottom corners of the room
Verify exterior seals are against the room at the top
corners and not turned in when the room is out (hori-
zontal seal overlaps vertical). Also, check for voids in
the seal on the slide roof and side panels.
Make sure weep hole in ramp pan is open and unob-
structed.
Room will not move in or out
Check the auto-resetting fuse located by the slideout
motor. (See the manufacturer’s manual).
Check battery condition and state of charge. Re-
charge if necessary.
Rollers leave tracks in the carpet as the room extends
This is normal. There are many pounds of weight
pressing these rollers down on the carpet and rollers
will compress the nap of the carpet down. Raking the
nap or vacuuming will solve the problem.

Table of Contents

Related product manuals