4. LCD Diagnostic: Enter this option and press the Left/Right arrow key to do LCD Diagnostic (you will notice that the
color of the LCD will be changing). Press the right softkey to quit.
5. System Monitoring: Displays RSSI, battery voltage, and RPN information.
6. Vibration (DP730 only): Press the “Vibrate” key to test if the device vibrates normally. Press the right softkey to quit.
7. Acceleration Sensor (DP730 only): Displays X, Y, Z coordinates. Change the handset position and check new values.
Press the right softkey to quit.
8. Proximity Sensor (DP730 only): Cover the proximity sensor, when the sensor is covered, the gray dot displayed on
the screen will become green. Press the right softkey to quit.
Factory Functions
DP Handsets Firmware Upgrade
The DP handsets can detect if new firmware is available when it is registered to a base station.
Firmware Notification
To upgrade the firmware on your handsets, follow the steps below:
1. Press Menu to bring up the operation menu.
2.
Use arrow keys to reach Settings .
3. Navigate to select Firmware Upgrade and press the softkey “Select”.
4. The LCD screen will display a prompt message to confirm the firmware downloading / upgrading press the right softkey
“Back” to dismiss the upgrade process.
The user can also provide the HTTP/HTTPS server username and password from the handset for provisioning purposes, this can
be done on the handset under Settings → System Settings → Provision Auth.
To Next Page
Loading...
