Users can enable the Off-Cradle Pickup feature to automatically answer incoming calls after picking up DP Handsets from its
cradle. Incoming calls will be automatically answered using earpiece mode.
To activate/deactivate the off-cradle pickup:
Using DP Handsets Menu
1. Press Menu to bring up the operation menu.
2. Select Preferences 🡪 and navigate to Off-Cradle Pickup using the up/down arrow keys.
3. Switch between Enabled/Disabled using the left/right arrow keys and “Save” after Enabling / Disabling the option.
Using DP75x Base Station Web Interface
1. Access DP75x Base Station Web Interface.
2. Go to DECT 🡪 Handsets Settings 🡪 HS# Settings.
3. Set “Enable Onhook on Cradle Reposition” to “Yes”. (By default, set to “No”).
Ending Calls
To terminate the calls, press the Hang-Up key .
On-Cradle Hang-up
Users can enable the On-Cradle Hang-up feature to automatically end ongoing calls after placing DP Handsets on its cradle.
To activate/deactivate the on-cradle hang-up feature:
Using DP Handsets Menu
1. Press Menu to bring up the operation menu.
2. Select Preferences 🡪 and navigate to On-Cradle Hang-up using the up/down arrow keys.
3. Switch between Enabled/Disabled using the left/right arrow keys and “Save” after Enabling / Disabling the option.
Using DP75x Base Station Web Interface
1. Access DP75x Base Station Web Interface.
2. Go to DECT 🡪 Handsets Settings 🡪 HS# Settings.
3. Set “Enable Off-hook on Cradle Pickup” to “Yes”. (By default, set to “No”).
Rejecting Calls
To reject an incoming call, press the Hang-Up key or “Reject” softkey (right softkey)
Direct IP Call
Direct IP calling allows two parties, that is, a handset and another VoIP device, to talk to each other in an ad hoc fashion
without a SIP proxy.
Elements necessary to complete a Direct IP Call:
Both DP Base station and other VoIP Devices, have public IP addresses, or
Both DP Handsets and other VoIP Devices are on the same LAN using private IP addresses, or
Note
DP Handsets should be resting on their cradling and then picked up for this feature to work.
The “Auto Answer” feature should be set to “No” to work properly.
To Next Page
Loading...
