Using DP75x Base Station Web Interface
1. Access DP75x Base Station Web Interface.
2. Go to DECT 🡪 Handsets Settings 🡪 HS# Settings.
3. Set “Disable Call Waiting Tone” to “No”. (Default is No).
4. Press the “Save and Apply” button to confirm.
Do Not Disturb
You can activate or deactivate the DND mode for your accounts registered on the handsets under the call settings. If DND
mode is activated for a specific line, all incoming calls will receive busy treatment depending on your configuration (forward
to voice mail, busy tone…)
To enable or disable the DND mode, follow the next steps
1. Press Menu to bring up the operation menu.
2.
Use arrow keys to reach Call Features 🡪 navigate to the Do Not Disturb sub-menu.
3. Select the account on which you want to enable/disable the DND mode and then press “Select”
4. Choose between Enabled and Disabled options and press softkey “Save” to accept the changes, a prompt message will
be displayed to confirm that the DND is enabled / disabled.
You can navigate to Status 🡪 Line status to check if the DND mode is enabled on the base station.
You can also navigate via the web interface of DP Base Station 🡪 Status 🡪 Line Options.
Call Forward
The call forward feature will allow you to forward all incoming calls to the desired number. Three possible call forward types
are available on the DP Handsets.
Forward all Dest: All incoming calls are immediately forwarded.
Forward Busy Dest: Incoming calls are immediately forwarded if the line is busy.
Forward No Answer Dest: Incoming calls are forwarded if not answered after a period of time.
To enable the call forward, please refer to the following steps:
1. Press Menu to bring up the operation menu.
2.
Use arrow keys to reach Call Features 🡪 navigate to the Call Forward sub-menu.
3. Select the account on which you want to enable/disable the call forward feature and press “Select”.
4. Select the type of call forwarding enter the number to forward the calls, and then press “Save” (left softkey) to apply the
settings, a prompt message will be displayed to confirm that the new settings have been saved successfully.
Paging
The DP Handsets support paging other handsets internally without having any sip Account registered. Similarly to the base
station paging button, Inter-Handsets paging features enable handsets to ring other handsets. The feature can be enabled
from the LCD menu 🡪 Call Features 🡪 paging.
Note
You can switch between active/on-hold calls by pressing Options 🡪 Swap.
To Next Page
Loading...
