Or;
Long press the digit “1” key to dial the configured Voice Mail feature code using Default Line.
Push to talk (PTT)
The DP Handsets support the push-to-talk (PTT) features which is a technology based on the instantaneous communication
commonly employed in wireless cellular phone services using a button to switch the device from voice transmission mode to
voice reception mode. This feature is similar to the “walkie-talkie” used and the PTT mode switches a phone from full duplex
mode, where both parties can hear each other simultaneously, to half duplex mode, where only one party can speak at one
time. Multiple parties to the conversation may also be included.
1. Users could press and hold the Push-to-talk key from any screen to quickly initiate a PTT call.
PTT Call Establishment
2. Available handsets (subscribed to the same base station) will receive the PTT call.
3. Keep holding the PTT key while speaking.
The channel status will change to Sending PTT to indicate that you are transmitting as displayed on the following screenshot.
PTT Transmission
To terminate PTT call, press button.
Notes
Users can access directly voicemail menu directly to play messages, by clicking on “View” (left softkey) when the notification
of a new voicemail pops up on the DP Handstet’s LCD screen.
If the VM is protected by a password, users can enter the password using the DP Handset keypad after reaching the Voice
Mail system. The password is defined on the service provider or IP-PBX side.
Note
To Next Page
Loading...
