Figure 3: Tab on the Handset Cradle
Connecting the GRP260x
To set up the GRP2600, follow the steps below:
1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a router (LAN side of the router) using the
Ethernet cable.
3. Connect the PSU output plug to the power jack on the phone; plug the power adapter into an electrical outlet. If a PoE
switch is used in step 2 (GRP2601P/GRP2602P/GRP2603P/GRP2604P only), this step could be skipped.
4. The LCD will display the Grandstream logo. Before con tinuing, please wait for the date/time display to show up.
5. Using the phone embedded web server or keypad configuration menu, you can further configure the phone using either a
static IP or DHCP.
Connecting to Wi-Fi Network (GRP2602W only)
– On the LCD menu, navigate to “Settings 🡪 Wi-Fi settings” and enable Wi-Fi.
– Select “Wi-Fi Network” and GRP2602W will automatically start scanning within the range.
– A list of Wi-Fi networks will be displayed. Select the desired network, and if required, enter the correct password to connect.
– Users can add and connect to a hidden network by accessing “Wi-Fi” Network” and then press on Add softkey . Then
enter the Network’s information.
Notes:
When the GPR2602W is not connected to any network (including Ethernet and Wi-Fi), a prompt interface will pop up to
notify users about it. Users can quickly enter the “Wi-Fi Network” page by pressing on the Wi-Fi softkey.
For easy deployment, The GRP2602W is preconfigured out of the box to connect to a default SSID named wp_master
with a password (WPA/WPA2 PSK) equal to wp!987@dmin, users can adapt these settings from the web UI as well to
make it easier for deployment on customer site.
To Next Page
Loading...
