PPPoE Account ID Enter the PPPoE account ID.
PPPoE Password Enter the PPPoE Password.
PPPoE Service Name Enter the PPPoE Service Name.
Ipv4 Address Enter the IP address when static IP is used.
Subnet Mask Enter the Subnet Mask when static IP is used for IPv4.
Gateway Enter the Default Gateway when static IP is used for IPv4.
DNS Server 1 Enter the DNS Server 1 when static IP is used for IPv4.
DNS Server 2 Enter the DNS Server 2 when static IP is used for IPv4.
Preferred DNS Server Enters the Preferred DNS Server for IPv4.
IPv6 Address
IPv6 Address Type
Allows users to configure the appropriate network settings on the phone to obtain IPv6
address. Users could select “Auto-configured” or “Statically configured” for the IPv6 address
type.
Static IPv6 Address
Enter the static IPv6 address when Full Static is used in “Statically configured” IPv6 address
type.
IPv6 Prefix Length
Enter the IPv6 prefix length when Full Static is used in “Statically configured” IPv6 address
type.
IPv6 Prefix(64 bits)
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in “Statically configured” IPv6
address type.
DNS Server 1 Enter the DNS Server 1 for IPv6.
DNS Server 2 Enter the DNS Server 2 for IPv6.
Preferred DNS server Enter the Preferred DNS Server for IPv6.
802.1X
802.1X mode
Allows the user to enable/disable 802.1X mode on the phone. The default value is disabled. To
enable 802.1X mode, this field should be set to EAP-MD5, users may also choose EAP-TLS,
or EAP-PEAPv0/MSCHAPv2.
Note: EAP-PEAP encryption supports Microsoft servers.
802.1X Identity
Enter the Identity information for the 802.1x mode.
Note: Letters, digits and special characters including @ and – are accepted.
MD5 Password
Enter the MD5 Password for the 802.1X mode.
Note: Letters, digits and special characters including @ and – are accepted.
802.1X CA Certificate
Uploads / deletes the 802.1X CA certificate to the phone; or delete existed 802.1X CA
certificate from the phone.
To Next Page
Loading...
Need help?
General
