Figure 4: Upgrading Status
Important:
Do not select different models of Access Points as they may not have the same firmware version.
Please do not interrupt or power cycle the GWN76xx AP or GWN7000 Router during upgrading
process.
During upgrade process GWN76xx LEDs will be blinking in green, and turn to solid green
indicating successful firmware update. If firmware update fails, GWN76xx LEDs will be solid red.
Single Upgrade
Instead of upgrading multiple units at once, users can perform an upgrade to a single paired access points
if needed
1. Click on next to the paired device to access its configuration page
2. Scroll down and click on to upgrade the device.
Note: Make sure that firmware server path is set correctly under System Settings->Maintenance before
starting upgrade process.
To Next Page
Loading...
