HARDWARE INSTALLATION
GWN7600 can be mounted on the wall or ceiling, Please refer to the following steps for
the appropriate installation.
Wall Mount
1. Position the mounting bracket at the desired location on the wall with the arrow pointing
up.
2. Use a pencil to mark the four mounting holes (screw holes DIA 5.5mm, reticle hole DIA
25mm).
3. Insert screw anchors into the 5.5 mm holes. Attach the mounting bracket to the wall by
inserting the screws into the anchors.
3 4
Plastic Expansion
Bolt
PA3.5 x 20
Screw
Wall
To Next Page
Loading...
