Image not found or type unknown
Figure 75: Weather Update Settings
Note:
The default setting for “City Code” is “Automatic” and the weather information will be obtained based
on the IP location of the phone if available. Otherwise, select the “Self-defined city code” to manually
choose the wanted city.
On “Self-defined city code”, you can enter the zip code or the name of the city you want to show its
weather information on the screen.
Note: By entering only the name of the city, the phone is going to choose the best match; for this
reason, the city being displayed would have been mistaken. Example: in the case of entering “Dallas”,
the phone will not be able to know if the user means “Dallas, TX”, “Dallas, NC” or “Dallas, Scotland”,
and it will select by default “Dallas, TX”. It is better to specify than the name of the state/Country in the
case of similar city names.
Image not found or type unknown
Figure 76 : Weather Update City, Country
GRANDSTREAM NETWORKS
No image found
Page 97
To Next Page
Loading...
