Figure 4-14. Status
24.If the phone number is not registered please check out all the confirmation.
25.To test the outbound calls, pick up the previously configured IP (SIP) Phone and call to
an external number using the prefix “6” (i.e. 6-2235695). The call will use the registered
port of the gateway to connect to the call and you should be able to hear the ring tone.
To test the inbound calls, from the PSTN call to your public number which should be
connected to a registered port in GXW410x gateway, and after some rings you should
be able to reach the IVR configured in Elastix.
This step completes the procedure of configuration. Make sure you have configured all
the parameters correctly if you are facing problems. For advance configuration please
refer to the gateway manual cited in previous pages.
To Next Page
Loading...
