HT841/HT881 Call Features
CONFIGURATION GUIDE
The HT841/HT881 can be configured in one of two ways:
The IVR voice prompt menu.
The embedded Web GUI on the HT841/HT881 using PC’s web browser.
Obtain HT841/HT881 IP Address
HT841/HT881 is by default configured to obtain the IP address from the DHCP server where the unit is located. To know which IP address is assigned
to your HT841/HT881, you should access the “Interactive Voice Response Menu” of your adapter via the connected phone and check its IP address
mode.
Please refer to the steps below to access the interactive voice response menu:
1. Use a telephone connected to the FXS port of your HT841/HT881.
2. Press *** (press the star key three times) to access the IVR menu and wait until you hear “Enter the menu option “.
3. Press 02 and the current IP address will be announced.
Understanding HT841/HT881 IVR Menu
The HT841/HT881 has a built-in voice prompt menu for simple device configuration which lists actions, commands, menu choices, and descriptions.
Connect an analog phone to FXS port. Pick up the handset and dial “***” to use the IVR menu.
Flash/Hook
Toggles between active call and incoming call (call waiting tone). If not in conversation, ash/hook will switch to a new channel for
a new call.
# Pressing pound sign will serve as Re-Dial key.
Menu Voice Prompt Options
Main Menu “Enter a Menu Option”
Press “*” for the next menu option
Press “#” to return to the main menu
Enter 01-05, 07,10, 12-17,47 or 99 menu options
01
“DHCP Mode”,
“Static IP Mode”
“PPPoE Mode“
Press “9” to toggle the selection
If using “Static IP Mode”, congure the IP address information using menus 02 to 05.
If using “Dynamic IP Mode”, all IP address information comes from the DHCP server automatically
after reboot.
If using “PPPoE Mode”, congure PPPoE Username and Password from web GUI to get IP from your
ISP.
02 “IP Address “ + IP address
The current WAN IP address is announced.
If using “Static IP Mode”, enter 12-digit new IP address. You need to reboot your HT841/HT881 for
the new IP address to take Effect.
03 “Subnet “ + IP address Same as menu 02
04 “Gateway “ + IP address Same as menu 02
05 “DNS Server “ + IP address Same as menu 02
07 Preferred Vocoder
Press “9” to move to the next selection in the list:
To Next Page
Loading...
