To Next Page

To Previous Page

~5~ ~6~

1. On LCD menu, press Menu key and navigate to Settings →

Network Settings → Wi-Fi.

2. Set Wi-Fi to “On” and navigate to “Wi-Fi Settings”. A list of

Wi-Fi networks will be displayed.

3. Select the desired network to connect to. (Enter the correct

password to connect if requested)

WP820 will display Wi-Fi icon on top of the main LCD menu if

the connection to the Wi-Fi network is successful.

1. On LCD menu, press Menu key and navigate to Settings →

About → Network Status to obtain the IP address.

2. Type the phone’s IP address in your PC browser.

Note: The computer needs to be on same network as WP820.

3. The default administrator username and password are

“admin”; the default end-user username is “user” and the

password is “123”.

Refer to online documents and FAQ for more detailed

information: http://www.grandstream.com/our-products

This device complies with part 15 of the FCC Rules. Operation is subject to

FCC warning

This device complies with part 15 of the FCC Rules. Operation is subject to

the following two conditions:

(1)The device may not cause harmful interference, and

(2)this device must accept any interference received, including interference

that may cause undesired operation.

Changes or modification not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed

to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with instructions, may cause harmful

interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

RF Radiation Exposure Statement:

This equipment complies with FCC RF radiation exposure limits set forth

for an uncontrolled environment. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.