Why are the cut corners rounded or too pointed on my GRAPHTEC Cutter?
If the cut corners made by your GRAPHTEC Cutter are either rounded or too pointed, the issue is likely due to an incorrect CUTTER OFFSET value for the blade you are using. To resolve this, adjust the CUTTER OFFSET value. If the corners are rounded, the value is too low. If the corners are too pointed, the value is too high.
General| Model | FC3100-60 |
|---|---|
| Manufacturer | Graphtec |
| Cutting Width | 600 mm |
| Interface | USB, Serial |
| Command Sets | HP-GL, GP-GL |
| Weight | 30 kg |
| Type | Cutter |
| Cutting Area | 600 mm x 50 m |
| Resolution | 0.0254 mm |
| Programmable Resolution | 0.025 mm |
| Power Supply | AC 100-240V |
| Operating Environment | Temperature: 10 - 35 °C, Humidity: 35-85% RH (non-condensing) |
Detailed technical specifications of the plotter, including dimensions and performance.
Explanation of the plotter's control panel buttons, lamps, and functions.
Overview of different cutter blades, their specifications, and applications.
Step-by-step guide for replacing cutter blades in various cutter pens.
How to properly adjust the cutter blade depth for optimal cutting.
Guidelines for setting parameters to achieve the best cutting quality.
Guide for replacing and adjusting internal mechanical components.
Diagram showing the layout of key components on the main control board.
Procedures for checking the plotter's power supply unit operation and protection.
Guide to configuring the plotter's functions using DIP switch settings.
Procedure to reset plotter settings to default by clearing non-volatile RAM.
Procedure for adjusting X and Y motor offsets using an oscilloscope.
How to adjust the pen offset using an oscilloscope and trimmer.
Procedure for automatic adjustment of the pen servo system.
Steps to set the correct cutting force for different media.
Procedure for fine-tuning plotter performance using gain adjustment software.
How to calibrate the plotter for precise distance accuracy.
Procedure to test the functionality of various plotter sensors.
How to test if all control panel keys are functioning correctly.
Common problems with cutting results and their causes/solutions.
To Next Page