Need help?Do you have a question about the GRAPHTEC FC5100-130 and is the answer not in the manual?
General| Model | FC5100-130 |
|---|---|
| Category | Cutter |
| Manufacturer | GRAPHTEC |
| Operating System Compatibility | Windows, MacOS |
| Repeatability Precision | ±0.1 mm |
| Number of Tool Mounts | 1 |
| Media Hold-Down Method | Electrostatic |
| Media Type | film |
| Blade Type | Supersteel blades |
| Interface | RS-232C |
| Power Supply | 100-240V AC, 50/60Hz |
| Drive Method | Digital servo drive |
| Mechanical Resolution | 0.005 mm |
| Programmable Resolution | 0.025 mm |
| Command Sets | GP-GL, HP-GL |
| Operating Environment | 10 to 35°C, 35 to 75% RH (non-condensing) |
Guidelines for safely handling sharp cutter blades to prevent injury.
Instructions on connecting the plotter to a computer via various interfaces.
Instructions on how to safely replace cutter blades and adjust offset values.
Detailed steps for loading sheet and roll media into the plotter.
How to register and adjust cutting conditions for optimal results.
Procedure to set the cutting origin point on the media.
Defining the effective cutting area using Upper Right and Lower Left points.
Configuring parameters for aligning pre-printed media using registration marks.
Blade control for cutting thick and thin materials, preventing common issues.
Function to smooth curves by adjusting the blade offset angle.
Function to print a list of current cutting condition settings.
Procedure for running the plotter's self-test to check its functions.
Guide to diagnosing and solving common plotter operational problems.
Information on the sensor for automatically locating registration marks.
Details on 2-point and 3-point methods for axis alignment.
Procedures for aligning coordinate axes using two or three-point methods.
Adjusting the plotter's origin point relative to registration marks.
Determining corrective values to adjust the registration mark sensor precision.
To Next Page