Advanced Functions and Settings: RS-232C Serial Interface
103
• Press the F2 key or the F3 key to select the X or Y Axis. Press the UP or DOWN
ARROW key to set the DISTANCE ADJUST parameter. DISTANCE ADJUST can
be set from -2.00% to +2.00% in 0.05% increments.
• Press the F4 key to reset the DISTANCE ADJUST parameter to 0% on the X and
Y Axises.
• Press the ENTER key to register your settings.
RS-232C Serial Interface
The RS-232C Serial interface of your plotter conforms to the RS-232C Standard
of Electronic Industries Association (EIA). This serial interface performs the serial
transfer of digital binary data, control signals and SYNC signals.
DISTANCE ADJUST
CONDITION 1... X = 0.00%.
Y = 0.00%.
RESET>.
Table 1: RS232 Serial Interface Specifications
Standard CCITT V.24, EIA RS-232C, JIS X5101
Synchronization Asynchronous start-stop
Transfer Rate 19200 bits/s
Stop Bit 2 s t o p bits
Parity Even, odd, none
Character length 7 or 8 bits
To Next Page
Loading...