Advanced Functions and Settings: COPY - Copying the Data in Plotter Buffer Memory
69
• Press the ENTER key, the following menu will appear:
The plotter will start cutting/plotting as soon as the ENTER key is pressed.
If you wish to continue cutting additional copies, reload the media and begin
again by pressing the COPY key.
NOTE: If there is an interval of ten seconds or greater when the data is sent, the previ-
ous data is cleared.
Copying
Sequence
The following figures illustrate the sequence in which copies are cut, with the
shaded areas representing the uncut areas of the media.
CONDITION 2........14.
30.
COPY.............4.
CB09Ux...0.
Copies are normally
cut in this sequence.
If MIRROR mode is
selected, the copies
are cut in this
sequence.
If ROTATE mode is
selected, the copies
are cut in this
sequence.
To Next Page
Loading...