Preparing to Cut: Loading Media
40
To load sheet media:
• Lower the media set lever to raise the pinch rollers.
• Move the left pinch roller next to the middle pinch
roller.
• Move both the left and middle pinch rollers
together until they reach the right stop.
• Load the media so that the left side of the narrow
media is under the left pinch roller.
• Adjust the right pinch roller over the right side of
the media.
• Raise the media set lever to lower the pinch roll-
ers.
• Lower the pinch rollers (raise the lever) and pull
the vinyl out from the alignment bar.Turn on the
power if it is off.
• Plotter performs the initialization routine.
• Loading of the media is complete.
Roll Media To load rolled media:
• Place the roll of media on the media stocker. Use the yellow markings to locate
the grit rollers. Place the media so that its edges align with the grit rollers.
V 1.12 GL
Buffer RAM Checking
Good Pinch Roller Position
Roller Location Guide
To Next Page
Loading...