Advanced Functions and Settings: TANGENTIAL EMULATION - Cutting Thick & Thin Material
95
• Press the F4 key to select FUNCTION 2.
• Press the F4 key to select TANGENT EMULATION.
• Press the F4 key to toggle between ENABLE/DISABLE.
• Press the LEFT or RIGHT ARROW key as required to enable/disable the tangen-
tial emulation mode per each condition of numbers. Press the UP or DOWN
ARROW key to select ENABLE or DISABLE. The V mark appears when enable
is selected for that tangential emulation mode.
• Press the ENTER key to register your settings or press the MENU key to cancel
MENU mode.
In READY status, the message TANGENTIAL appears along with the condition
menu when the condition on which the enabled tangential emulation is selected.
Setting Overcut An overvcut function is available when tangential emulation is enabled. The
overcut function enables the plotter to cut a line longer that the cutting data speci-
fies. Overcutting eliminates uncut portions when using thick material. You can
specify the covercut length by entering the start and end points of the overcut.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
DATA SORTING>.
AXIS ALIGNMENT>.
AUTO PRE FEED>.
TANGENT EMULATION>.
TANGENT
EMULATION.
MODE>.
ENABLE/DISABLE>.
TANGENTIAL.EMULATION
.........
CONDITION 1 2 3 4 5 6 7 8
| xxVxxxxxVxxxx
CONDITION 6.........38.
TANGENTIAL RREADY ..60.
READY TANGENTIAL ....2.
CB15U-K30x...0.
To Next Page
Loading...