Special Precautions: Handling the Cutters
11
Handling the Cutters
• The tip consists of a sharp blade. Be
sure not to extend it too far.
• Instructions on replacing the blade
or adjusting the blade length are
provided in Cutters and Holders.
Attaching a Cutter Pen
WARNING: To avoid bodily injury, do not touch the pen tip after the plotter is turned
on.
WARNUNG:Um das Risiko einer Verletzung herabzusetzen, sollten Sie niemals das
messer berühren während der Schneidplotter arbeitet.
Follow the procedure below to attach a cutter pen to the pen carriage.
Sharp Blade
1 Make sure that the pen holder
screw is loose.
2 While positioning the pen
holder upward, push the cutter
pen all the way into the holder
until its rim contacts the pen
stopper.
Flange
Pen Holder
To Next Page
Loading...