GRAPHTEC FC5100-130 - Enabling Tangential Emulation

Advanced Functions and Settings: TANGENTIAL EMULATION - Cutting Thick & Thin Material
94
slow due to the excessive up/down pen movements of MODE 1, select MODE 2 to
shorten the cut/plot time. Remember that the cutting quality with MODE 2 is infe-
rior to that of MODE1.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
• Press the F4 key to select FUNCTION 2.
• Press the F4 key to select TANGENT EMULATION.
• Press the F3 key to select mode.
• Press the F3 key to select MODE 1 or press the F4 key to select MODE 2.
• Press the ENTER key to register your settings or press the MENU key to cancel
MENU mode.
Enabling Tangen-
tial Emulation
Tangential emulation control can be individually enabled or disabled by pen con-
dition.
• Press the MENU key to select MENU mode.
• Press the NEXT key two times.
INTERFACE>.
AREA PARAMETERS>.
FUNCTION 1>.
FUNCTION 2>.
DATA SORTING>.
AXIS ALIGNMENT>.
AUTO PRE FEED>.
TANGENT EMULATION>.
TANGENT
EMULATION.
MODE>.
ENABLE/DISABLE>.
TANGENT
EMULATION.
MODE 1>.
MODE 2>.