Advanced Functions and Settings: AXIS ALIGNMENT - Axis Alignment Parameter Setting
84
• Press the F1 key to select ROLL-1, press the F2 key to select ROLL-2, press the
F3 key to select SHEET. The following menu appears:
The plotter immediately begins sorting when it receives the cut data from the
PC.
If CANCEL is selected, return to the previous menu.
• Press the MENU key to cancel the menu mode.
NOTE: The plotter immediately begins sorting when it receives the cut data from the
PC, however, the cutting/plotting may experience a delay due to the data sort-
ing process. While the plotter is data sorting, following key operations becomes
invalid.
Direct keys: COPY, ORIGIN, AXIS ALIGNMENT, CONDITION, F KEYS TO
SELECTING CONDITION NUMBER
Menu mode: All the functions except for PEN UP/DOWN, BUFFER CLEAR
and FEED
NOTE: Your data sorting setting is retained in the plotter’s internal memory even while
the plotter is turned off.
•
AXIS ALIGNMENT - Axis Alignment Parameter Setting
AXIS ALIGNMENT is a very important function that should be used when you
intend to cut pre-printed media, such as stickers or decals. When the media is
loaded in the plotter, it should be loaded at exactly the same angle and position as
it was on the printer which printed the images to ensure that the position of the
contour matches the printed images. Since this can not be done manually, the
AXIS ALIGNMENT function allows one to adjust the angle and position of the
media on the plotter electrically, as if it were being loaded on the same printer.
The direct key for AXIS ALIGNMENT is located on the operation panel so that
you can rapidly access this function.
Axis Alignment parameters should be configured prior to performing the AXIS
ALIGNMENT function. There are two main parameters: METHOD and TOOL
CONDITION 1........14.
........30.
SORTING... ........4.
CB09Ux...0.
DATA SORTING>.
AXIS ALIGNMENT>.
AUTO PRE FEED>.
TANGENT EMULATION>.
To Next Page
Loading...