Out of the Box: Connecting the Plotter
24
Connecting the Plotter
Connecting to
the Computer
The FC5100 Plotter is equipped with an RS-232 Serial Interface Cable in the
accessory kit.
1 Connect the 25-pin connector to the
RS232-C connector on the plotter and
tighten the screws. If you are using a
Centronics-compatible parallel interface
cable, connect the 36-pin connector to
the Parallel connector on the plotter and
lock the levers.If you are using a USB
connentor, connect the connector to the
USB connector on the plotter.
2 Connect the 9-pin connector to the
connector on the computer COM port
and tighten the screws. If your computer
has a 25-pin connector port, use the 9-
pin to 25-pin adapter that is supplied in
the accessory kit.
RS-232C
Parallel
USB
To Next Page
Loading...