Out of the Box: Installing the Accuload System
23
8 Secure the media alignment bar to the tabs at both ends with M4 screws.
9 Install the stock rollers into the holes on the rear side of the media brackets.
NOTE: Be sure to tighten all the screws to ensure accurate media loading. The Accu-
load™ system may not function properly if even one of the screws is loose.
NOTE: Be sure to place the plotter on an acceptable work surface. Refer to dimen-
sions below:
FC5100-75: 45 inches (114cm) wide by 19 inches (48cm) deep.
FC5100-100: 57 inches (144cm) wide by 19 inches (48cm) deep.
FC5100-130: 67 inches (170cm) wide by 19 inches (48cm) deep.
Media Alignment Bar
Groove
M4 Screw
M4 Screw
Rear
Front
Stock Rooler
To Next Page
Loading...