Need help?Do you have a question about the GRAPHTEC FC5100-100 and is the answer not in the manual?
Procedures for safely handling sharp cutting blades and holders to prevent injury.
Step-by-step guide for correctly inserting and securing a cutter pen into the pen holder.
Verifying all standard accessories are present after unpacking the plotter.
Details on different blade types, their applications, and compatibility with plungers.
Diagrams and labels identifying the components of cutter pens.
Instructions on how to safely replace cutter blades, including offset value considerations.
Overview of the plotter's control panel, including indicator lamps and key functions.
Detailed instructions for loading both sheet and roll media correctly.
Choosing the appropriate media type (ROLL-1, ROLL-2, SHEET, CONTINUE) for the loaded material.
Registering and fine-tuning eight groups of cutting conditions (force, speed, quality, offset).
How to manually set the cutting origin point for jobs.
Defining the effective cutting area by setting Upper Right and Lower Left points.
Setting parameters for aligning pre-printed media using registration marks.
Diagnosing and resolving plotter problems based on symptoms, causes, and solutions.
Setup and use of the sensor for automatically locating registration marks for axis alignment.
To Next Page
General