Preparing to Cut: Initializing Routine
47
Press the F4 key to select CONTINUE
No sensing operations are performed. Set the various functions of the plotter as
desired.
NOTE: Make sure to set the correct cutting conditions to suit the cutter blade and
media being used. For details see Setting Conditions.
Initializing Routine
ROLL-1 1 During initialization, the pen carriage moves right until it detects the mechani-
cal home position.
2 The pen carriage then moves left until it detects the left-hand side of the media
edge.
3 It then returns to the right edge of the media.
4 The media is fed backwards until the media’s leading edge is detected.
ROLL-1>
*
ROLL-2>*
SHEET>*
CONTINUE>*
To Next Page
Loading...