Options: FC5100 Pounce Tool Manual
158
Select Pounce Tool
from the Menu
• Press the function key [F1] through [F4] corresponding to the number of the
group whose registered tool you wish to change.
• Press the CONDITION key to select the tool.
• Press the F4 key to select the tool you wish to use.
• Press the RIGHT or LEFT ARROW key to scroll through the tool selection until
you select POUNCE to use the pouncing pen.
• Press the ENTER key to select POUNCE.
Pounce Conditions To change the setting of a group of conditions, press the function key [F1] to
[F4] corresponding to the number of the group you wish to change. For example,
press the F4 key to select CONDITION 8. If CONDITON 4 appears, then press the
F4 key again to select CONDITION 8.
• Press the CONDITION key to access the condition menu.
• Press the NEXT key to cancel the condition where you are currently set and
return to the main menu.
T
O CHANGE THE POUNCE FORCE
• Press the F1 key to change FORCE. The blinking cursor indicates that you can
change its setting
• Press the UP or DOWN ARROW key to raise or lower the numeric value 1-40.
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• Press the ENTER key to register your setting.
T
O CHANGE THE POUNCE SPEED
• Press the F2 key to change SPEED. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value from 1
to 100. [1 to 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, 100.]
• Press the F1 key to change FORCE.
• Press the F3 key to change QUALITY.
• Press the F4 key to change OFFSET.
• Press the ENTER key to register your setting.
T
O CHANGE THE POUNCE QUALITY
• Press the F3 key to change QUALITY. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value 1 -8.
The smaller the value, the higher the quality. The smaller the value, the higher
To Next Page
Loading...