Background Settings: Background Settings for GP-GL
115
CAUTION: Always set the AREA function to limit the cutting area and protect the machine.
• Press the F3 key to select ENABLED or press the F4 key to select DISABLED. A
blinking cursor appears beside your choice.
• Press the ENTER key to register your setting and to proceed to the next menu.
Press the NEXT key if you wish to bypass this setting with no changes.
If you used METHOD 1 to select BACKGROUND SETTINGS, press the MENU
key if you do not wish to make any changes. If you used METHOD 2 to select
BACKGROUND SETTINGS, turn off the plotter if you do not wish to make any
changes.
Check Pen This setting is availabe when the 2 Pen option is installed. The 2 Pen option
installed machine can hold one blade or pen in the pen holder on the pen carriage
(which is referred to as PEN 1) and one pen in the pen holder on the right side
plate (which is referred to as PEN 2). This function is used to enable or disable
checking PEN 2.
When ENABLE is selected, the plotter checks to see if PEN 2 is installed. This
check if performed during the plotter’s initialization after selecting the media type.
When DISABLE is selected, the plotter does not check to see if PEN 2 is
installed uring the plotter’s initialization after selecting the media type.
CAUTION: If DISABLE is selected, the PEN 2 should be installed before turning on the
plotter.
• Press the F3 key to select ENABLED or press the F4 key to select DISABLED. A
blinking cursor appears beside your choice.
PINCH ROLLER SENSOR
ENABLED.
DISABLED_.
CHECK PEN
ENABLED.
DISABLED_.
CHECK PEN
ENABLED.
DISABLED_.
To Next Page
Loading...