GRAPHTEC FC5100-100 - Select the Media Type

Preparing to Cut: Select the Media Type
45
Select the Media Type
CAUTION: To avoid damaging the cutting mat, be sure to set the media type to SHEET
when using sheet media. Whenever possible, use sheet media of rectangular
shape.
If you have already loaded the media, the MEDIA TYPE menu appears. Select
the media type.
ROLL–1 Roll-1 detects the width and leading edge of roll media. The coordinate origin is
initialized with respect to the media’s leading edge.
Press the F1 key to select ROLL-1.
The initialization routine is executed to determine the paper size and origin
point.
CUT AREA shows the effective cut area that is determined by the position of the
pinch roller and the page length setting.
ROLL–2 ROLL-2 detects the width but the leading edge of the roll media is not detected
and the coordinate origin is initialized with respect to the cutting mat.
Press the F2 key to select ROLL-2
The initialization routine is executed to determine the paper size and origin
point.
ROLL-1>
*
ROLL-2>*
SHEET>*
CONTINUE>*
ROLL-1>*
ROLL-2>*
SHEET>*
CONTINUE>*
CUT AREA
X=2000mm Y=730mm
ROLL-1>*
ROLL-2>*
SHEET>*
CONTINUE>*