Preparing to Cut: Setting Conditions
50
The following is a list of all eight conditions and their respective settings.
NOTE: The selected conditions greatly affect the finished quality of cutting operations.
NOTE: Raising the SPEED and QUALITY values results in lower precision but
reduced overall cutting time. This is useful when making test runs.
NOTE: Lowering the SPEED and QUALITY values results in high-precision but
increased overall cutting time.
Select the Tool
from the Menu
Press function keys [F1] through [F4] corresponding to the number of the group
whose registered tool you wish to change.
• Press the CONDITION key to select the tool.
• Press the F4 key to select the tool you wish to use. A blinking cursor appears
next to your choice.
• Press the RIGHT or LEFT ARROW key to scroll through the tool selection.
• Select one of the following cutter blades: CB09Ux, CB15-10Ux, CB15Ux,
CB15U-K30x, CB15-10Cx, CB15-05Sx, CB15-10Ux, CB15UBx.
Condition Comments Tool Force Speed Quality Offset
1 Cutter CB09Ux 14 30 4 0
2 Pen PEN 14 60 4
3 Cutter Immediate CB09Ux 20 30 4 0
4 Cutter Reflective CB015Ux 30 15 4 0
5 Cutter High Intensity Reflective CB015Ux 38 15 4 0
6 Cutter Sandblast with Tangential
Emulation turned off
CB015U-K30x 38 10 2 0
7 Other OTHER 17 30 4 17
8 Pounce POUNCE 12 30 4 1
CONDITION 1........14.
30.
READY .........4.
CB09Ux...0.
SET.... ........14
CONDITION 1........30
4
CB09Ux...0
To Next Page
Loading...