GRAPHTEC FC5100-100 - Withdrawal of the Pen Carriage

Preparing to Cut: Withdrawal of the Pen Carriage
63
Withdrawal of the Pen Carriage
This function moves the pen carriage from its current position to a position that
is +100 mm away along both the X and Y axis. This also helps to confirm the job is
completed.
While holding down the ENTER key, press the UP ARROW key, and then
release it.
Repeat this process as needed to move the pen carriage away from the cutting/
plotting job.
Returning the Pen Carriage to Origin
This function moves the pen carriage from its current position to the origin point.
While holding down the ENTER key, press the DOWN ARROW key and then
release it. The pen carriage will return to the origin point.