GRAPHTEC FC5100-100 - SPEED - Setting the Pen-Up Speed

Advanced Functions and Settings: SPEED - Setting the Pen-Up Speed
96
Press the function key [F1] thru [F4] corresponding to the condition that enables
the tangential emulation mode and requires an overcut setting.
• Press the condition key.
• Set the parameters if necessary, then press the ENTER key to register your set-
tings.
• Press the F3 key or the F4 key to select the start point or end point. Press the
UP or DOWN ARROW key to set the overcut length. The overcut length can be
set from 0.0mm to 0.9mm in 0.1mm increments.
• Press the ENTER key to register your settings.
SPEED - Setting the Pen-Up Speed
To reduce the overall cutting time, this function allows you to set the traveling
speed of the pen in raised status, separately from the cutting SPEED setting.
• Press the MENU key to select MENU mode.
• Press the NEXT key three times.
• Press the F3 key to select OPTION 1.
CONDITION 6.........38.
TANGENTIAL RREADY ..60.
READY TANGENTIAL ....2.
CB15U-K30x...0.
SET.............38.
CONDITION 6.........60.
....2.
CB15U-K30x...0.
OVERCUT
START = 0.2mm.
END = 0.2mm.
.
BACKGROUND SETTINGS>.
OPTION 1>.
OPTION 2>.