GRAPHTEC FC5100-100 - Cutter Pen Nomenclature; Replacing the Cutter Blade

Cutters and Holders: Cutter Pen Nomenclature
28
Cutter Pen Nomenclature
WARNING: To avoid bodily injury, handle cutter blades with care.
PHP32-CB09N
Cutter Pen
(For cutter blades of 0.9 mm diameter)
PHP32-CB15N
Cutter Pen
(For supersteel cutter blades of 1.5 mm diameter)
PHP31-CB15 Cut-
ter Pen
(For ceramic and sapphire cutter blades of 1.5 mm diameter)
PHP32-CB09 Cut-
ter Pen
(For cutter blades of 0.9 mm diameter)
PHP32-CB15 Cut-
ter Pen
(For supersteel cutter blades of 1.5 mm diameter)
Replacing the Cutter Blade
WARNING: Will cause injury to the operator.
Various types of plungers are available which correspond to the diameter and
type of blade used. Check the cutter blade you are going to use and its appropri-
ate cutter offset value against the table below:
)
Plunger
cap
Cap A blade B adjustment
Protective Plunger Holder Cutter Holder Blade length
knob (red)
Plunger Spring Cutter Plunger Holder Blade length
Cap blade adjustment knob
(blue)
Plunger Cutter Plunger Holder Blade length
cap blade adjustment knob
(red)
Plunger
Cap
Spring Cutter Blade Plunger Blade length adjustment knob (blue)
Plunger
Cap
Cutter Blade Plunger Blade length adjustment knob (red)