GRAPHTEC FC5100-100 - Setting of AXIS ORIGIN OFFSET

Options: FC5100 Auto Registration Mark Sensor
183
• Press the F2 key to select DISTANCE ADJUST.
• Press the F2 key to select DISABLED for the automatic distance adjustment
function. Press the F3 or F4 key to select the resolution for automatic distance
adjustment function. A  mark appears next to the current setting.
•
Press the ENTER key to register your setting. The following menu
appears. If you wish to set another parameter, press the key corre-
sponding to that setting.
• Press the MENU key to cancel menu mode when all of the parameters are set.
Setting of AXIS
ORIGIN OFFSET
Unless the origin point has been moved to a new position, it is always located in
the corner of the registration mark. Use the AXIS ORIGIN OFFSET function when
you wish to move the origin of the plotter.
In order to set the origin point of the cutting data to match the cutting data and
pre-printed image, you must know the location of the axis origin point from the reg-
istration mark. Next, use the following procedure to set the axis origin point a spe-
cific distance from the corner of registration mark 1.
• Press the MENU key to select MENU mode.
• Press the NEXT key.
• Press the F1 key to select AUTO REG. MARK.
MARK SIZE>*
DISTANCE ADJUST>*
AXIS ORIGIN OFFSET>*
PAPER-WEIGHT>*
DISTANCE ADJUST
DISABLED*
1 mm RESOLUTION *
15 mm RESOLUTION *
MARK SIZE>*
DISTANCE ADJUST>*
AXIS ORIGIN OFFSET>*
PAPER-WEIGHT>*
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*