GRAPHTEC FC5100-100 - POINTS Method

Options: FC5100 Auto Registration Mark Sensor
175
• Press the F1 key to select AUTO REG. MARK
• Press the F1 key to select MARK SCAN MODE
• Press the F3 key to select the 2-POINTS Method
• Press the F2 key to select DISABLE when you do not wish to use the AUTO
REG. MARK sensing function. A  mark appears next to the current setting.
• Press the ENTER key to register your setting. If you select the two-points
method the next setting menu appears. Continue to set other parameters or
press the NEXT key to return to the previous menu.
• Press the MENU key to cancel the menu mode if you select DISABLE, or when
all of the parameters are set.
3 POINTS METHOD
The three-points method requires you to enter REGISTRATION MARK 1, MARK 2,
MARK 3 and the AXIS ORIGIN POINT. The AXIS ORIGIN POINT may be located at
the same position as MARK 1. To enter this information into the plotter:
• Press the MENU key to select MENU mode
• Press the NEXT key
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
MARK SCAN MODE *
DISABLED *
2POINTS*
3POINTS *
MARK SCAN MODE *
DISABLED*
2POINTS *
3POINTS *