Options: FC5100 Auto Registration Mark Sensor
176
• Press the F1 key to select AUTO REG. MARK
• Press the F1 key to select MARK SCAN MODE
• Press the F4 key to select the 3-POINTS Method
• Press the F2 key to select DISABLE when you do not wish to use the AUTO
REG. MARK sensing function. A mark appears next to the current setting.
• Press the ENTER key to register your setting.
• If you select the 3-POINTS method, the next setting menu appears. Continue to
set other parameters or press the NEXT key to return to the previous menu.
• Press the MENU key to cancel the menu mode if you select DISABLE, or when
all of the parameters are set.
AUTO REG. MARK SETTING MENU SHORTCUT
• Lower the media set lever.
• Press the F4 key to select INITIAL MENU.
AUTO REG. MARK>*
PEN UP/DOWN>*
BUFFER CLEAR>*
FEED>*
MARK SCAN MODE>*
MARK TYPE>*
OTHER SETUPS>*
SENSOR OFFSET ADJ>*
MARK SCAN MODE *
DISABLED *
2POINTS *
3POINTS*
MARK SCAN MODE *
DISABLED*
2POINTS *
3POINTS *
LOAD MEDIA !*
INI* INITIAL MENU>*
To Next Page
Loading...