Advanced Functions and Settings: FEED - Advancing the Media
71
• This menu appears 3 seconds after you select BUFFER CLEAR.
• Press the F3 key to clear the buffer or press the F4 key to resume the cutting/
plotting job.
• If the F3 key is pressed, the following menu appears, clearing of the buffer is
then complete.
• Press the MENU key to cancel MENU mode.
FEED - Advancing the Media
The FEED function is used to prevent the loaded media from slipping by auto-
matically advancing the media and imprinting it with grit roller marks; the media is
then returned to its original position.
If you know approximately how much media you will require for the next cut,
advance the media prior to starting the cut by using this function. Otherwise,
enable the AUTO PRE-FEED FUNCTION.
CAUTION: Do not use the FEED function with media that is shorter than 1 meter. If the
FEED LENGTH setting exceeds the actual length of loaded media, the media
will fall out in front of the plotter. If this happens, shorten the FEED LENGTH.
• Press the MENU key to select MENU mode.
• Press the NEXT key.
NOTE:
CONFIRM DATA FROM.
HOST STOPPED.
BUFFER CLEAR OK?
CLEAR>.
CANCEL>.
CLEARING BUFFER !
PLEASE WAIT
BUFFER CLEAR
COMPLETED !
To Next Page
Loading...