GRAPHTEC FC5100-100 - Setting Distance Adjust Parameter

Advanced Functions and Settings: DISTANCE ADJUST - Adjusting the Length of Line Segments
102
• Press the F4 key to select OPTION 2.
• Press the F3 key to select DISTANCE ADJUST.
• Press the RIGHT or LEFT ARROW key to move the cursor to the number of the
condition group you wish to use under DISTANCE ADJUST. Press the UP or
DOWN ARROW key to enable or disable the DISTANCE ADJUST function.
When the DISTANCE ADJUST function is enabled a “v” mark appears.
• Press the ENTER key to register your settings.
• Press the MENU key to cancel the MENU mode.
Setting Distance
Adjust Parameter
Press the [F1] thru [F4] key to select the number of the condition requiring dis-
tance parameter adjustment.
• Press the CONDITION key.
• Set the parameters if necessary, then press the ENTER key to register your set-
tings.
.
BACKGROUND SETTINGS>.
OPTION 1>.
OPTION 2>.
.
INITIAL DOWN FORCE>.
DISTANCE ADJUST>.
TEST>.
DISTANCE ADJUST
.........
CONDITION 1 2 3 4 5 6 7 8
xV| x... xxx xxx
CONDITION 1.........14.
30.
READY TANGENTIAL ....4.
CB09Ux...0.
SET.............14.
CONDITION 1.........30.
....4.
CB09Ux...0.